b'OILCOP GEN II ACCESSORIESOILCOP GEN II TMACCESSORIES1 Turbine Pulse Meter with a 5.5 mm, 90 jack plug.P/N100388-01 AC/DC Power Supply Adapter, 12 VDC1 turbine pulse meter ideal for use with DEF and waterP/N100851FLUID MGMT.applications, flow range is 1.526Power supply/adapter has GPM with a working pressure of up toan input voltage range of 145 PSI. Inlet/Outlet fittings are 1 male BSPP,100240 VAC, 50/60 HZ, two BSPP x 1 NPTF stainless steel adapters are included. with U.S. and EU plug adapters, rated at 2.0 amps with an output voltage of 12 VDC rated 3/4 24 VDC Stainless Steel Solenoid Valve at 2.0 amps. DC output cord is 15 ft. with a 5.5.mm, P/N540085-A 90 jack plug.This is a 2-way, normally closed solenoid valve with SS body and Viton seals. Pressure rated to 115 PSI, max flow rate is 50 GPM, ideal for use with water and DEF applications. Inlet/Outlet fittings are 3/4 NPTF.Red Conductor1 24 VDC Stainless Steel2 Conductor Cable (per foot) Black ConductorSolenoid Valve P/N100710P-XXOILCOP GEN II ACCESSOrIESP/N540085-B Two strand, 20 gauge, shielded, plenumShieldThis is a 2-way, normally closedrated wire cable used to connect any OilCop solenoid valve with SS body andGen II module in cases where wirelessShield DrainViton seals. Pressure rated to 115 PSI,communication is not desired or not practical. max flow rate is 50 GPM, ideal for use with water and DEFSold by the foot, or in rolls of 1,000 feet.applications. Inlet/outlet fittings are 1 NPTF. 4 Conductor Cable (per foot) Red ConductorP/N100709P-XX White ConductorPOE/Gen II (Power Over Ethernet) Four strand, 18 gauge, shielded, Green ConductorP/N100849 plenum rated wire cable used to Black ConductorThis adapter plugs into the Local Areaconnect the Tank Monitor ModuleShieldNetwork (LAN) and 115 VAC outlet to (TMM) to the Tank Overfill Alarm andShield Drain24 VDC air solenoid valve for control of provide a data connection as well asDouble Diaphragm evacuation pumps electrical power to the CDM via aat used oil/fluid pickup stations and to single cable. extend tank probe wiring. Sold by the foot, or in rolls of 1,000 feet.AC/DC Power SupplyAdapter, 24 VDC Two Strand Jumper CableP/N100850Power supply/adapterP/N907118has an input voltageTwo strand, 18 gauge power jumper cable for use in connecting range of 100240 VAC,24 VDC power to a maximum of ten PSMs in series (Daisy 50/60 HZ, rated at 2.5 amps with an outputChain); NOTEfirst PSM receives power from 24 VDC Power voltage of 24 VDC rated at 5 amps. AC power cord is 4.5 ft. long,Supply, P/N 100850.with a three - prong grounded plug. DC output cord is 15 ft. long, www.liquidynamics.com 57'